PACKING LIST
1) Calypso 360 AL:
Boat Hull, Oars, Foot Pump, Pressure Gauge, Wooden Seat, Docking Rope, Safety Grab Rope, 4
Screw 1 Drain Valve, Repair Kit and Carry Bag, 3 pieces Aluminum Boards, 1 piece Wooden
Board, 4 Pieces Stringer, Bench Bag, Front Storage Bag and Boat Cover.
2) Calypso 420 AL:
Boat Hull, Oars, Foot Pump, Pressure Gauge, Wooden Seat, Docking Rope, Safety Grab Rope, 5
Screw 1 Drain Valve, Repair Kit and Carry Bag, 3 pieces Aluminum Boards, 1 piece Wooden
Board, 4 Pieces Stringer, Bench Bag, Front Storage Bag and Boat Cover.
INSTALLATION TIPS
Tip 1: Make sure to tuck in the aluminum floor edge correctly into the aluminium stringers.
Tip 2: Make sure to press down and turn the pop-up spring valve 90 degrees before inflating. (The default
setting is for deflation.)
Tip 3: If using an electric pump, after tube inflation, use a foot pump to add a little more air to ensure
correct pressure.
Tip 4: In case the valve is loose, screw it tight with the black plastic wrench included in the accessories.
Tip 5: In case you find difficulty when installing the bench seat, put your knees on one of the inflated
tubes to add pressure to the bench handle.
HOW TO SET UP THE BOAT?
STEP ONE: STARTING UP
1. Unfold the hull
Clear a flat area (make sure it is clean and free of sharp objects). Remove the hull from box and take off
the plastic bag. Unroll the hull and lay it out flat.
2. Screw Valve Installation
1
2.2
UP
DOWN
(A) INFLATE
(B) DEFLATE
2.1
PRESS AND TURN 90
1. Take off the top of the valve. (The valve
by default is at deflation position)
2. Pressing down the spring switch and turn it clockwise
by 90 degrees. Make sure the switch is popped up. Note:
To deflate, press the inner button at the center and turn
counterclockwise 90 degrees.
5
