Reference: Silvalea Ltd - Sling Fitting Instructions
Fastfit Sling
Code/s: 001, 001HS, 002, 002HS, 1PL, 1PLHS, 2PL & 2PLHS
Revision: July 2009
Copyright & Design Rights: Pauline Guilfoyle 1999
A risk assessment must be carried out to ensure that the correct size and style of sling has been met before use.
1.
Ensuring that the sling label is facing out wards, glide the body of the sling down the back of the client, just past
the base of the spine.
2.
Take left leg section of the sling and glide under the clients left thigh and back up between their legs ensuring that
the fabric is not twisted. Repeat for the right leg section. Feed one leg tape through the other closest to sling to
prevent the clients legs from abducting during transfer.
3.
Head support fitting (if applicable).
a. Roll head support to desired position.
Feed head support straps through the shoulder straps and back through the slider, adjusting the position
via the slider.
b. The Arched head support is self-supportive.
Under no circumstances should the head support tapes be attached directly to the spreader bar of the hoist.
Doing so may cause tearing to the sling and compromise the safety of the client.
4.
Attach each of the shoulder tapes onto the spreader bar of the hoist ensuring that the corresponding coloured
loops are used on each side. Attach each of the leg section tapes to the spreader bar of the hoist, again ensuring
that corresponding coloured loops are used on either side.
5.
Slings fitted with additional intermediate straps (Hip Tapes)
If the hoist is fitted with a 3-claw cradle fitting, place the loop of the additional strap over the centre claw. If the
hoist has a 2-claw fitting, place the loop of the additional strap over the same claw as the leg loops.
6.
Once you are happy that all tapes are correctly & securely attached to the spreader bar of the hoist, the transfer
can commence.
Do not attempt to lift your client until you are satisfied that the four/six tape fixings are securely attached to the
spreader bar and you are happy that the sling is the correct size and fit for your client.
Whilst every attempt is made to instruct a safe move you must conform to the current Moving and Handling
regulations/procedures. If in any doubt, consult your Moving & Handling Advisor.
Standard Sling Range
Fastfit Sling
(Replacement)
Instructions for use
001
1PL
001HS
Poly
Mesh
Certificate No. FM 35946
