Silux Control SC-TS01, Руководство по эксплуатации

Страница: 6 / 12

I. Installing the Thermo Stabilizer
®
1. Ensure that the main switch to the device you wish to control
is off.
2. Cut the wire going to the device and strip a small piece of the
insulation plastic from all the wires. No wire should be exposed.
3. Unscrew the plastic cover and push the wire coming from the
mains (110V ~ 230V) through the centre gland and the wire
going to the Thermo Stabilizer
®
to the output A terminal and tighten
the screws.
4. Remove your current thermal couple from your water heater and
replace it with the supplied Silux
©
thermal couple. Push the
connector coming from the Silux
©
thermal couple through the small
gland and plug it into the socket on the Thermo Stabilizer
©
.
*Please Note: The thermal couple is necessary to get live
temperature readings and keep the water at the selected
temperature.
5. Tighten all the glands and screw the plastic cover back on
again. You can mount the Thermo Stabilizer
®
to a desired location
using the mounting holes on the side of the Thermo Stabilizer
®
with
the supplied plugs and screws.
6. Turn the main switch to this device on. The RED light on the
front of the device will switch on. This means the Thermo
Stabilizer
®
has power.
*Please Note: There is a green light for output A and a green
light for output B of the Thermo Stabalizer
®
which switches on
to show the corresponding devices is on.
II. Replacing the CR2032 3V battery
There will be one CR2032 battery included with the product. This
battery is used to keep time and date as well as schedules in case of
power disruptions.The battery will have a life span of up to 1-2 years,
depending on how the Thermo Stabilizer
®
is used.
We recomend switching the Thermo Stabilizer
®
’s power off before
changing the battery.
1. Open the plastics with a star screw driver.
2. Pop out the old CR2032 battery and replace it with the new
CR2032 battery.
3. Place the Thermo Stabilizer
©
cover back over the plastics and
screw tight.
*Please Note: It’s not necessary to pair the Silux Control
®
devices again after replacing the battery.
III. How to pair with your smart device:
Please remember that the IntelliHub
®
needs to be powered to be
able to control the Thermo Stabilizer
©
from your smart device.
Please refer to the user manual of the IntelliHub
®
for pairing the
Thermo Stabilizer
©
to your Android or iOS device.
IV. How to pair with the Touch Lamina
©
Take note: When pairing directly to the Thermo Stabilizer
©
the
button only controls Output A.
1. A red light will indicate that the the Thermo Stabilizer
©
has
power. Press the Teach button on the Thermo Stabilizer
©
. The
green light on the Thermo Stabilizer
©
will start flashing.
2. Ensure the Touch Lamina
©
has power. Press the Teach button
on the Touch Lamina
©
. The green light on the Touch Lamina
®
will start flashing.
3. Tap the button on the Touch Lamina
®
corresponding to the
Silux
®
device you wish to pair with this device. The green light
will switch off on both devices after successfully paired.
If the green light stays on, the pairing was unsuccessful
and you should wait for 30 seconds for the green light to
go off before trying again.
Please refer to the Touch Lamina
®
and Seeker
®
manuals
regarding controlling your Thermo Stabilizer
©
from network
paired devices.