SILKN H4201, Инструкция по эксплуатации

Страница: 12 / 188

10
EN EN
7.2 Treatment steps
1. Make sure your skin is clean, dry and free from powder, cream or gel.
2. Make sure that the rubber cap (#2), filter (#3), and tip (#1) are firmly in place.
For your first few treatments, be sure to use the Fine tip .
3. Press the control button (#4) to turn on the device. Your ReVit Essential is
ready for use in low suction mode.
4. Apply the tip firmly to your skin so that you feel the suction.
5. Work each area as recommended in section “6.1 Treatment areas”.
6. To move from low to high suction mode, press the
control button again.
7. To switch off the device after treatment, short press the control button
once or twice, depending on which suction mode you are in.
8. Unplug the device and store ReVit Essential in its original box. Please refer
to section “8. Maintenance and storage”.
7.3 After treatment
Avoid direct sunlight immediately after treatment, and apply sun
factor SPF 30 or higher.
You may wish to apply a facial mask, or apply a day or night
cream.
8. Maintenance and storage
It is important to clean your Silk'n ReVit Essential device and store it properly
after each treatment.
L
First, unplug the device.
L
To clean the device, wipe with a clean, dry cloth. Use a cleaning
fluid with no more than 70% alcohol, or another non abrasive
cleaning fluid. Never use acetone or other abrasive fluids, because
they will damage your device.
L
To clean the tip , first remove it from the device, wash with soap
and water, then dry thoroughly.
L
To clean the filter , first remove it from the device, brush away any
debris using a soft brush, and place it back on the device.