Silicon Graphics Rackable H2106-G7, Руководство пользователя системы

Страница: 42 / 112

18 007-5683-004
2: Server Installation
Check the CPUs (processors)
Standard factory systems ship with four processors installed into the serverboard. Each processor
needs its own heatsink.
Check the System Memory
Your server system is shipped with system memory installed. Make sure all DIMMs are fully
seated in their slots. For details on adding system memory, refer to
Chapter 3 .
Install Expansion PCIe Cards
You can install expansion PCIe cards in the system. Refer to Chapter 3 for information on
installing PCIe expansion cards.
Check all Cable Connections and Airflow
Make sure all power and data cables are properly connected and not blocking the chassis airflow.
Refer to
Chapter 3 for details on cable connections.
Check the Drive Bay Setup
Next, you should check to make sure the system disk drives and disk drive backplane have been
properly installed and all connections have been made.
Check the System Disk Drives
All drives are accessible from the front of the server. For servicing the DVD-ROM, you will need
to remove the top chassis cover. The hard drives can be installed and removed from the front of
the chassis without removing the top chassis cover. Depending upon your system configuration,
your system may have one or more drives installed. For detailed information about how to install
disk drives, see
“Hard Disk Drives (H2106-G7 Chassis)” on page 40 .
If you have more than 4TB of storage, you must create multiple volumes to fully utilize your
RAID disks.