Silicon Graphics 230, Руководство пользователя

Страница: 91 / 148

Error Messages
007-4263-001 75
Correcting Error Conditions
As a general rule, if an error message says
Press F1 to continue
, it is caused by a
configuration problem, which can be easily corrected. An equipment malfunction is
more likely to cause a fatal error, i.e., an error that causes complete system failure.
Here are some corrective measures for error conditions:
1. Run Setup. You must know the correct configuration values for your system before
you enter Setup, which is why you should write them down when the system is
correctly configured. An incorrect configuration is a major cause of power-on error
messages, especially for a new system.
2. Remove the system unit cover. Check that the jumpers on the system board and any
expansion boards are set correctly.
3. If you cannot access a new disk, it may be because your disk is not properly
formatted or partitioned. Please consult your operating system documentation for
additional information.
4. Check that all connectors and boards are securely plugged in.
If you go through the corrective steps above and still receive an error message, the cause
may be an equipment malfunction.
If you are sure that your configuration values are correct and your battery is in good
condition, the problem may lie in a damaged or defective chip.
In either case, contact an authorized service center for assistance.
The BIOS Utility allows you to view your system’s configuration settings.
When you receive the system, it will already have been configured by SGI. There is no
need to run Setup when starting the computer unless you get a
Run Setup
message.
The Setup program loads configuration values into the battery-backed nonvolatile
memory called CMOS RAM. This memory area is not part of the system RAM.
Note: If you repeatedly receive
Run Setup
messages, the battery may be bad. In this
case, the system cannot retain configuration values in CMOS. Replace the battery or call
for support.