Silicon Graphics 230, Руководство пользователя

Страница: 46 / 148

30 007-4263-001
2: Installation of Customer Replaceable Components
6. Remove the screw located on the inside of the system’s upper panel. See Figure 2-10
for the location of the screw.
Figure 2-10 Removing Power Supply Inside Screw
7. Pull the power supply out of the system, avoiding any physical contact between the
power supply and any system component.
8. To install the power supply, keep the system resting on its right side.
9. Carefully place the power supply into its housing, and push it into place.
10. Replace the inside screw shown in Figure 2-10.
11. Replace the two rear screws shown in Figure 1-2 on page 3.
12. Connect the power supply cables to the system board, the hard drive(s), the
CD-ROM drive, and to the floppy disk drive. Refer to Figure 2-11 for the location of
the power supply cable connections.
Power supply
inside screw