Silicon Graphics 10-Gigabit Ethernet Network Adapter, Руководство пользователя

Страница: 26 / 38

3: Operating the Adapter
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
Interrupt:62
Enabling the Adapter
To enable the adapter, enter the following:
# ifconfig
IPaddress
broadcast
broadcastaddress
netmask
netmaskvalue
For other systems to see the new address, you must enter the new hosts addresses in
DNS or in
host
files or NIS as required for your system.
For details, see the operating-system specific documentation about networking.
Verifying that the Adapter is Properly Configured and Enabled
IRIX Adapter Configuration Verification
To verify that the network interface is configured properly and is enabled on, enter
the following on an IRIX system:
irix% /usr/etc/netstat -ia
Columns with the following headings should appear:
Name Mtu Network Address
In the
Name
column, the
xg
number should appear. If it is followed by an asterisk
(
*
), the interface is disabled.
In the
Mtu
column, the size of the current maximum transmission unit (MTU) should
appear. The MTU size is set via the
-mtu
switch of the
ifconfig
command. If no
size is specified by the
-mtu
switch, the adapter defaults to an MTU size of 1500.
In the
Network
column, the IP network address should appear.
In the
Address
column, the canonical MAC address of the adapter should appear,
which looks similar to the following:
08:00:69:0b:e0:41
10 007–4669–002