8
Installation Instructions - Intergrated Application
Preparing the
Enclosure
FOR YOUR SAFETY:
While performing
installations described in
this section, gloves, safety
glasses or goggles should
be worn.
Tools You Will
Need
Carpenters
Square
Measuring
Tape
Level
Drill & Hole Saw Set
Gloves
Safety Glasses
Flashlight
Electrical Requirements:
The appliance must be
connected to an individual
properly grounded electrical
outlet, protected by a 15 or
20 ampere circuit breaker or
time delay fuse.
•
It is recommended that you do
not install the beverage center
into a corner (i.e. directly beside
a wall). This is to allow the
door(s) to have a greater then
90° opening swing. A limited
door swing will prevent the
shelves from sliding out as
intended, and may lead to dam-
aging the door gasket(s).
•
The rough cabinet opening
must be on a level floor area
and at least 25” deep by 24”
wide. The opening should also
have a height of at least 35”.
•
The electrical outlet may be
positioned from within either
side of the adjacent cabinetry, or
the rear of the shaded area (as
shown in Fig D.).
•
If the electrical outlet is located
inside the adjacent cabinetry, cut
a 1-1/2” diameter hole to admit
the power cord. If the cabinet
wall is metal, the hole edge
must be covered with a bushing
or grommet.
Electrical Access
Fig
Cabinets
Square
and
Plumb
35”
From
Underside of
Countertop to
Floor
24”
6”
2”
24”
Min.
1-1/2” dia. hole
*if electical outlet
is in adjacent
cabinetry
D
25”
1
1
/2” diam. hole
* If electrical out-
let is in adjacent
cabinetry.
34
3
/4” from
underside
of
countertop
to floor
Cabinets
square
and
plumb
Fig D
