Silent Witness SWX80, Руководство пользователя

Страница: 9 / 20

5
2. Carefully pull the bezel towards you until it is clear of the camera.
Note The bezel and camera fit closely together and separating them
may require using a little force. Be sure to pull the camera
straight out of the bezel. After the camera starts to slide out,
the airtight seal will break and the camera then slides out easily.
3. Set the bezel and camera down in a place where the tempered glass window
cannot be scratched.
Figure 2 Camera Side View
4. Your camera comes set up from the factory. If you need to make minor
adjustments, refer to the procedures below to adjust the switch settings, iris
level, focus, and vertical phase (24 VAC).
Caution Silent Witness does not recommend changing the dip
switches other than the vertical phase and focus controls.
These dip switches are factory configured for optimal
performance. If further adjustments are required please
feel free to contact Silent Witness Customer Service or
authorized service personnel.
Caution During the entire time the bezel is off, ensure that the
camera board, lens, and LEDs are kept intact and free from
dust.
5. Slide the bezel enclosure over the camera and rotate the enclosure until it
slides into place. Tighten the security screws with the Allen key supplied, to
keep the bezel in place.
Security screws (x3)
SWX82 only Ring locking screws
Upper locking ring
Camera base
Balls and
sockets for
easy swiveling
and locking
Bezel
Lower locking ring