Silent Witness SWX80, Руководство пользователя

Страница: 8 / 20

Document 900.0255 Rev 1.00 June 9, 2004
4
Flush and Surface Mount
1. Loosen, but do not remove the security (locking) screws on the lower and
upper locking rings (see
Figure 2 ).
2. Loosen the lower and upper locking rings to access the mounting screw holes.
Once the locking ring is loosened you can adjust the camera position for easier
access to the four mounting screw holes.
3. Screw the camera base to the desired position on the wall, ceiling, or top of
pole. Use four screws appropriate to your installation to mount the camera.
Note See page 14 for the SWX80 and SWX81 mounting template and
page 15 for the SWX82 mounting template.
Make sure the camera is mounted on a flat, smooth surface.
For Surface Mounting only: To ensure a waterproof installation, the notch
in the camera base that the power and video connections exit through should
be facing down. If the power and video connections exit the top of the base
(wall mounted only), water may pool in the camera base. Apply appropriate
sealant around the notches and any other gaps between the camera base and
the mounting surface.
Step 3: Position the Camera
Caution Do not swivel and position the camera without the bezel
firmly in place. Avoid handling the camera board or lens to
position the field of view as this may damage the camera.
1. Loosen the security screws on the lower and upper locking rings.
2. Loosen the locking rings and move the camera into position. Swivel the camera
to capture the desired field of view. Tighten the locking rings to set the
position.
3. Lock the camera into position using the Allen key supplied to tighten the
locking screws on the locking rings.
Step 4: Adjust the Camera
Note If necessary, adjust the camera after it is mounted firmly in
position. Any new changes to the camera position may require
further adjustment of the zoom and focus.
1. Loosen, but do not remove, the three security (locking) screws on the bezel
with the Allen key supplied (see
Figure 2 ).
One security screw is located under the sunhood. This screw is accessible
through the sunhood by removing the small, black, rubber plug.