17
Menu Options Explained
G-SENSOR
The G-Sensor senses the G-Force movement of the vehicle, if the camera notices a anomaly it will activate
the sensor and lock the video file. E.g if the vehicle is travelling down the road and suddenly the driver
brakes hard, the camera will detect something has changed in the driving pattern and will lock the file, if
the G-Sensor has been activated. The G-Sensor has different levels to choose from allowing you to change
this depending on the type of vehicle you have, and the terrain your vehicle travels on.
E.g if the vehicle is a;
Family car , travels up and down a road - The sensor would be set around 2G
Working Van, travels on and off building sites - The sensor would be set around 3G
HGV, travels on roads but the vehicle is loaded - The sensor would be set around 4G
If you feel that the G-Sensor is too Low or too High, just alter this accordingly, remember that the video
can be locked manually please see page 5 reference “DOWN” Key
LOOP SETTING
The loop setting allows the device to recycle old video footage, we recommend a 5 minute video loop.
When the camera is recording, every five minutes the camera will make a new
video file, and when the card is full it will delete and record over the top of the oldest file.
Please note - If you set the option to OFF the camera will record until the SD card becomes full, and will
then stop recording, and the SD card will need to be formatted before the camera will record again.
PARKING MODE
Parking Mode is CCTV an option, if the option has been switched on, the camera will turn off with the ve-
hicle, and
requires 2 things to work 1. the G-Sensor must be switched on 2. The camera must have a full battery.
E.g If the vehicle is rocked and the G-Sensor is activated the camera would switch on and start to record,
once the movement has stopped the camera would stop recording and switch off.
This does not require any permanent power supply, and will work if there is enough charge in the battery
and the G-Sensor to be set accordingly.
MOTION DETECTION
Motion Detection is a CCTV option just like “parking mode” but 2 differences. “Motion detection” requires
a permanent battery source and instead of working on motion, it works on motion through the lens.
The camera will be in sleep mode until it detects a motion in the camera lens, once it has seen this move-
ment it will wake up and start recording. When the motion has stopped, it will stop recording and go back
to sleep.
This option does require a permanent battery source, also this option requires you to manually switch off
when using the camera as a dash camera.
The user is responsible for switching “Motion detection” and “Parking mode” On and Off, failure to
switch the option off, whilst driving could result in loss of data.
