11
Using the Tuner
1.
With the power ON, press the TUNER switch to enter the Tuner Mode. The LED display lights
when in the Tuner Mode (tuner standby).
2.
Tune the string until the note name of the desired pitch appears in the display.
* Output is muted when in the Tuner Mode.
3.
Tuning is complete when the “ ” in the middle of the “
” display lights.
4.
Press the TUNER switch again to return to the Play Mode.
* After pressing the TUNER switch, it may take several seconds for the tuner to detect the pitch and display the
note name.
* The note name and tuning display may not be able to track continuous changes in pitch. When tuning, adjust
the pitch in stages.
* The tuner may not be able to detect the pitch of sounds with too many overtones or with too short a decay.
l
Calibration (Setting the Standard Pitch)
The tuner’s standard pitch can be set between A=438 to 445Hz (default setting: 440Hz).
1.
In the Tuner Mode, press the TUNER switch for more than one second and the last digit of the cur-
rent standard pitch will appear in the display for approximately two seconds.
2.
Pressing the TUNER button while the last digit is displayed cycles the standard pitch setting in one
Hz increments from 440Hz (default) → 441Hz → 442Hz → 443 Hz → 444 Hz → 445 Hz → 438 Hz
→ 439 Hz → 440Hz → ....
3.
Waiting two seconds after selecting the standard pitch, the digit disappears from the display setting
the standard pitch, and returns the display to the normal tuner mode.
* The calibration setting is retained when the power is switched OFF.
Pitch is low
→ → →
→ → →
Pitch is high
Pitch is tuned
