11
green.
→
The receiver now executes automatic and manual travel
commands.
Pressing the selection button in the central channel for longer
(approximately 1 second) changes the Auto or Manual operating
mode for
all the individual channels
. A different operating mode
for individual channels (auto and manual) is set on switching for all
channels to Auto operating mode.
Programming the transmitter
Requirement
The receiver is installed.
Check whether the channel has been
deleted
or in the correct mode according to the status display.
Stand in front of the blind to be programmed while programming.
1. With receivers which have already been installed, switch the
circuit breaker off and on again after a few seconds.
The receiver is now in programming mode for about 5 minutes.
2. Press the programming button
P
on the back of the unit brie
fl
y
(approximately 1 second) until the status display lights for a
short time. The blind moves up and down for approximately two
minutes, showing that the receiver is in programming mode.
3. Press the
OPEN
button as soon as the blind starts moving in
Open direction (within 1 second at the most). The status display
lights brie
fl
y.
The blind stops brie
fl
y, starts moving again, stops and then
moves in the Close direction.
4. Immediately (within no more than 1 second) after close travel
has started, press the
CLOSE
button. The status display lights
brie
fl
y. The blind stops. The transmitter channel is programmed.
Note
The blind must be programmed again if it does not stop.
A bidirectional programming process in the hand-held
transmitter can be cancelled by pressing the STOP button for
6 seconds.
Explanation of functions
