IM_FULL_SL52FM_REV_A
17
P R O F E S S I O N A L S E R I E S
RPM LEARNING:
While the system is in Start Feature
“D”
programming mode,
1. Press and release the transmitter button once,
[1]
LED flash,
[1]
horn chirp to indicate you are in features “RPM
Learning mode”.
2. Start the vehicle with the key. (While the engine is running, the parking light & LED will flash, if not, please check the
tachometer White/Red wire connection.
3. Press and hold the valet switch for 2 seconds until a long chirp and the LED light is constant for two seconds. The
RPM signal is learned.
4. Once you complete step 3, you can adjust and test “Check Level”
Exit:
Press the button on the transmitter.
RETURN TO START FEATURE FACTORY DEFAULT SETTING:
Press the button first within 3 seconds, then press the + button on the transmitter together for 6 seconds, there
will be a confirmation six chirp with 3 long chirp and parking light flash 3 times to confirming the system “Start Feature C &
D Programming all returns to factory default setting.
SHUTDOWN DIAGNOSTICS
The unit has the ability to report the cause of the last shutdown of the remote start system.
Enter:
1. Turn the Ignition ‘switch to ‘ON position.
2. Press the button on the transmitter.
3. The LED will now report the last system shutdown by flashing for one minute in the following grouped patterns:
LED
Flashes
Shutdown Mode
1
(-) Safety Shutdown input (Hood)
1. Close the hood.
2. Check White / Black wire connection.
2
(+) Safety Shutdown input (Brake)
or Neutral Safety Switch input fail.
1. Check White/ Violet wire connection.
2. Move the Enable Toggle Switch to “ON” position. (If installed.)
3. Move the gear selector to “Park”/ “NEUTRAL” position.
4. Check Black/White wire connection.
3
No RPM or
Low Voltage.
Tachometer Checking Type:
Check White/Red wire connection
Voltage Checking Type:
Program the “CHECK LEVEL” from
“Hi Check Level” to “Low Check Level”
5
Over-rev
6
System timed out
7
Transmitter
8
Tach. Signal has not been learned
Re-learning the RPM
(Start Feature D – 2 / 3)
