Silca Triax Quattro, Руководство по эксплуатации

Страница: 26 / 118

Operating Manual - English Triax QUATTRO
- 18 - Copyright Silca 2011
1
4.2
USING THE R1+R12 CLAMP
The machine comes with the “R1+R12” clamp shown below in (Fig. 13).
R1:
for cutting security keys
R12: for engraving keys and medals
A1
S
Fig. 13
ATTENTION: to calibrate the R12 clamp, turn the knob (S) anticlockwise to fully close the
2 jaws (A3-A4).

The clamp comes with 2 locking notches that allow proper positioning for the operation involved (clamp
R1, R12).
- loosen the handle (A6) by one turn and pull the anatomical grip (A8) towards the operator to release
the clamp so that it can slide from side to side.
- release the anatomical grip (A8) and move the clamp manually so that the positioner locks the clamp
on the first notch it finds. When the required clamp (R1 or R12) position is reached, close the grip (A6).

The R1+R12 clamp comes with a fixed plate (A2) on top, a mobile jaw in the centre (A3) and a mobile
jaw on the right (A4) which can be replaced when worn.

The clamp is also provided with 2 calibration plates (A1) for the Z axis (sprung), one for R1 and one for
R12 which the cutter uses to home itself at the beginning of the cutting or engraving process for a new
key or medal.

The plates are sprung to avoid micro splits on the cutter when making checks.
A2 A3
A4
A6
A5
Posizione R1
Posizione R12
S
A7
A8
Fig. 14

The R1 clamp is prepared for housing high security keys with head stops, or keys with tip stops.
The former (with head stops) are positioned up against the clamp (stop “0”) (Fig. 14) and the others (tip
stops) are positioned referring to one of the grooves (1-2-3) as shown on the machine display. Use the
bar provided for this operation (Fig. 15).
position R12
position R1