Silca Technica EU, Руководство по эксплуатации

Страница: 20 / 30

Operating manual - English Technica EU
16 Copyright Silca 2005
5 MAINTENANCE
ATTENTION: for repairs or replacement of parts for maintenance, the ‘CE’ mark is guaranteed only if original spare parts
provided by the manufacturer are used.
Although the TECHNICA EU key-cutting machine does not require special maintenance, it is advisable to check
and, if necessary, replace the parts subject to wear, such as: the belt, cutting tool, tracer point. Replacement is
simple and can be carried out by the operator.
ATTENTION: to keep the machine well maintained we recommend using protective oil, e.g. WD40 or similar, applied to
the burnished mechanical parts. This prevents oxidation of the parts in question (clamps, guides,
carriages...).
Before starting any type of maintenance (checks or replacements), read the instructions below:
•
NEVER CARRY OUT MAINTENANCE OR SERVICING WITH THE MACHINE SWITCHED ON
.
•
ALWAYS REMOVE THE MAINS PLUG
.
•
FOLLOW ALL THE INSTRUCTIONS IN THE MANUAL TO THE LETTER
.
•
USE ORIGINAL SPARE PARTS
.
5.1 Cleaning
• keep the carriage and clamps free of chippings from the cutting operations by cleaning with a dry
brush.
• Do not use oily substances or solvents to clean the painted surfaces, clamps or electrical
connectors.
• Under no circumstances must compressed air be used to clear the work area of chippings, as these
may find their way into the working parts of the machine.
5.2 Carriage replacement
ATTENTION: Turn the machine off and unplug it.
1) Loosen the 2 knobs (F) (fig. 21) y two
turns and remove the carriage, pulling it
to the left.
2) Fit the new carriage from left to right, into
the dovetail groove, taking it all the way
in, then secure by tightening the 2 knobs
(F).
3) Check machine gauging.
Fig. 21
5.3 Replacing the tracer point
Proceed as follows to replace the tracer point (D) (fig. 22):
ATTENTION: turn the machine off and unplug it.
1) Loosen the screw (D3).
2) Remove the worn tracer point.
3) Fit the new tracer point, pushing all the way in. Ensure that the seat
is clean.
4) Tighten the screw (D3).
5) Re-calibrate the machine, following the procedure described in
chap. 4.6.2, page 13.
Fig. 22
F
D3
D