Silca Optika, Руководство по эксплуатации, Страница: 31 / 60

Optika Operating manual - English
Copyright Silca 2017 27
1) Press ENTER, the display will show:
2) Turn the ENTER knob to select the type of key to be searched for (the description will be highlighted
by a yellow strip over black characters).
3) Press the ENTER button and the display will show the message (the same for all types of keys):
There are 2 ways of using “Compare Cuts”.
• Select "New Reading" when in Optika’s memory there is NOT a read key, useful for the comparison.
• Select "Last Reading" when in Optika’s memory there is a read key, useful for the comparison.
6.2.1 MATCHING FROM "NEW READING"
4) Turn the ENTER knob to "New reading" and press ENTER to confirm; the display will show:
5) Fit the original key.
Fig. 31
6) Before confirming the reading operation, press the ENTER button to make sure the key is properly
aligned (the top yellow bar must be just a vertical line). If not, follow the instructions in ch.6.1.
7) Confirm with ENTER, a few seconds later the display will show:
Fig. 32
8) Make sure the left-hand yellow bar should point upwards as much as possible. If not, follow the
instructions in ch.6.1.
Select key type:
Flat - Shoulder stop
Flat - Tip stop
Bit male
Bit female
Matching key from:
Last reading
New reading
Insert original key Insert original key
L:2707
key alignment bar
L:2419
key alignment bar key-fitting bar
left-hand bar (profile luminosity) left-hand bar (profile luminosity)