AG02
Identification English
AG02 · Date
31.10.2012 · Art.
No.
82270 · Mod.
status
354/12
37
3 Identification
Please check the particular type of unit and type number from the identifi-
cation plate. Type number and the corresponding version are indicated in
the delivery documentation.
e. g.
AG02
-
0023
version number
type of unit
4 Installation
4.1 Mechanical mounting
Loss of type of protection
Loss of the type of protection caused by worn sealing rings in the ball bea-
ring and radial shaft seals.
`
Operate the actuator within the admissible parameters (see chapter
).
Destruction of main bearings
Improper installation (e. g. tension on the driving shaft) causes additio-
nal heat development and destruction of the actuator in the long term.
`
Ensure a low shaft and angle offset between shaft and accommoda-
tion bore by applying appropriate manufacturing methods (see
Actuator failure
`
When mounting pay attention to the IP type of protection (see chap-
ter
).
`
Owing to the type of protection screw all mating connectors (see chap-
ter
) to the actuator by applying min. 1 Nm.
`
Do not open the actuator yourself (exception: see chapter
).
`
Avoid impact on the device.
`
Do not modify the device in any way.
WARNING
CAUTION
CAUTION
