5
4.
When Windows resumes, the drivers install
automatically.
5.
The board is now ready for use.
Windows XP
Note:
If you have Windows XP with Service Pack
1 (SP1)
or later, the drivers will be installed
automatically by the operating system. Otherwise,
follow the instructions below.
1.
Install the board and boot up your system. At the
Found New Hardware Wizard
, click Cancel.
2.
Insert the driver CD. Click Start, Run, type in
X:\setup.exe
, then click OK. (Replace X: with the
drive letter of your CD-ROM)
3.
At the Found New Hardware Wizard, select Install
the software automatically (Recommended)
, click
Next
, then click Finish.
4.
If prompted, repeat step 3, otherwise go to step 5.
5.
Restart Windows to complete the installation.
Windows Server 2003
Windows Server 2003 has built-in driver support for this
controller. Just install the board and Windows will
automatically detect and install the correct drivers for it.
No additional driver is necessary.
To Verify Successful Driver Installation
1.
Check Device Manager to verify successful driver
installation.
Windows 98SE/ME: From the main desktop, right
click My Computer, then click Properties. Click
Device Manager
tab.
