4
2.
Insert the driver CD. Click Start, Run, type in
X:\setup.exe
, then click OK. (Replace X: with the
drive letter of your CD-ROM)
3.
Choose Yes, I want to restart my computer now,
then click Close to restart Windows.
4.
When Windows restarts, a USB 1.1 host is detected.
5.
At the Add New Hardware Wizard, click Next.
6.
Choose Search for the best driver for your device.
(Recommended)
, click Next.
7.
Clear all check boxes, click Next, and Next again.
8.
Click Next, then Finish.
Note:
If prompted for the Windows Installation
CD-ROM
, click OK. Insert this CD and click OK.
9.
Repeat steps 5-8 one more time when the second
USB 1.1 host is detected.
10. Windows now detects the USB 2.0 host and loads it's
driver.
11. The board is now ready for use.
Windows ME/2000
Note:
If you have Windows 2000 with Service Pack
4 (SP4)
or later, the drivers will be installed
automatically by the operating system. Otherwise,
follow the instructions below.
1.
Install the board and boot up your system. At the
Add New Hardware Wizard
, click Cancel.
2.
Insert the driver CD. Click Start, Run, type in
X:\setup.exe
, then click OK. (Replace X: with the
drive letter of your CD-ROM)
3.
Restart Windows after the driver installs.
