4
4. From
Choose Destination Location
window, click
Next
.
5. Remove the Driver Installation diskette, select
Yes
to restart
Windows and click
Finish
.
To verify successful installation in Windows NT 4.0:
1. Go to
Start / Setting / Control Panel
,
double click
SIIG Cyber
PCI 20X
device icon.
2. New
COM
port address and
LPT
number will be assigned for
the ports when successfully installed. The board is ready to
connect devices.
Note
If you plan to connect a parallel device other
than a printer to the parallel port, such as zip drive,
or scanner, please follow the next section to change
the port's I/O address to support these devices.
To change the I/O address in Windows NT 4.0:
1. Double click
Start, Settings, Control Panel
,
then
SIIG Cyber
PCI 20X
device icon.
2. Highlight the LPT or COM address and click
Settings
.
3. Select or type in an I/O address supported by the device you
would like to configure and click
OK
. Make sure the selected
I/O address does not conflict with other device in your system.
4. Select
Restart Now
for the new setup to take effect.
Windows 2000:
Windows 2000 will automatically detect and install the correct
driver for
Low Profile PCI -1S
and
Low Profile PCI -1P
.
To verify successful installation in Windows 2000:
1. Double click
My Computer
,
Control Panel
,
System
,
Hardware
,
and click
Device Manager
.
2. Click on the + (plus sign) in front of
Ports (Com & LPT)
.
3. New
Cyber port(s)
should be listed.
