-2-
BACKPLATE
BACKPLATE
SIGN
HOUSING
ALL INSTALLATIONS REQUIRE STANDARD TYPE 4" x 4" SQ x 2 1/8" DEEP J- BOX.
SET ADAPTOR PLATE ¼"- 3/8" BELOW FINISHED PANEL SURFACE
Before installing or connecting any primary power wiring,
DISCONNECT MAIN POWER SUPPLY AT THE CIRCUIT BREAKER OR FUSE.
WALL MOUNT
WALL MOUNT
1. Install J-Box 1/8"-1/4" below finished panel surface. Connect Power Module AC wiring to
building supply in J-Box, using wire nuts or connectors supplied.
BATTERY MODELS: BLACK: 120 277 VAC WHITE: Common
AC MODELS: Non- Polarized Line in.
2. Route wire nuts to side of J-box, insert Power Module into box and secure with 2 #8-32 box
screws.
NOTE: Power module orientation is universal, position as required to clear connectors
and wire nuts in J-box.
3. Remove back plate from sign assembly by inserting pin (small screwdriver or allen key)
into 2 release holes in top edge, press down to release clips and hinge cover away from
housing.
4. Support backplate on raised flat surface and knock out oval opening
in center.
NOTE: Remove any sharp edges around opening by file or sharp metal blade. Drill 3/16"
diameter holes at locations noted above. For additional support drill out 2 additional 3/16"
dia holes at left and right sides on center. Locate back plate in position on wall and mark
support holes; install wall anchors for support screws.
5. For battery backup models, connect 2-pin polarized battery plug.
6. Run LED lamp plug through backplate. Attach back cover to j-box with 2 #8-32 screws
supplied. Install and tighten 2 support screws. DO NOT OVERTIGHTEN.
7. Insert 2 tabs on base of sign assembly into slots in base of back cover. Connect LED lamp
plug.
8. Hinge sign assembly into position and snap closed.
To remove signs, repeat step 3.
W
ALL
POWER
MODULE
ADAPTOR
PLATE
BACKPLATE MT. SCREWS
#8-32 SELECT LENGTH
1/2" - 3/4"
REMOVE
K.O. FOR WIRING
DRILL OUT 3/16" DIA
IN TWO PLACES TO
MATCH
J-BOX LOCATION
DRILL 3/16" IN TWO PLACES
FOR ADDITIONAL WALL MT.
SUPPORTS
USING SCREW ANCHORS
1 1/2" SQ.
EXTENSION
AC POWER
INPUT
120/277 VAC
POWER MODULE
MOUNT SCREWS
#8-32 (2 REQD)
POLARIZED
LED LAMP
PLUG
GRD
J- BOX
4" x 4"
x 2 1/8"
LOWER
BRACKET
SPACER
TEST
PANEL
DIFFUSER
LENS
TEST SWITCH
AND LED
INSULATOR
PLUG
CONNECTOR
WIRING TO
POWER
SUPPLY
TEST PANEL ASSEMBLY
Series RPROBB & RPROAC
Rapier Open Face Die Cast LED System
Battery Backup & AC Models
03.15.03
