Signode TENSION-WELD VFX-9/13, Руководство по эксплуатации, частям и безопасности

Страница: 6 / 30

6
Never operate this tool using a bottled air
or gas source. Bottled air/gas sources do
not provide consistent operating
PNEUMATIC INFORMATION
AIR PRESSURE REQUIREMENTS
The VFX tool is designed to operate at an air pressure of 90 psig (6.2 Bar).
AIR PRESSURE VS. PERFORMANCE
The air pressure supplied to the VFX tool must be a minimum of 85 psig (5.7 Bar) If the air supply
pressure can be adjusted within a range from 85 psi to 90 psi (5.7 - 6.2 Bar) the VFX tool's
performance can be fine tuned to a particular application or operation preferences. Changing the
VFX air supply pressure to the tool will directly alter the rate at which the tool will take-up the
strap slack and the strap tension. Increasing or decreasing the VFX air supply within the
suggested 85 to 90 psig (5.7-6.2 Bar) range will not seriously affect the actual welding portion of
the strap cycle. After an initial "Break-In" period, the air motor may become more powerful. If the
tool's performance is effected by this increase in performnace, reduce the air motor output by
turning the adjustment screw (Key 47 on the Air Motor Assembly) counter-clockwise as required.
AIR SUPPLY INSTALLATION
If compressor has a good dryer unit, use black
pickled pipe. When a dryer unit is not installed,
use galvanized or copper pipe. To perform
reliably, a pneumatic tool requires a continuous
source of clean, water-free air at adequate
pressure. A Filter-Regulator-Lubricator (FRL)
unit must be installed as close to the air tool as
possible, preferably within 10 feet (3M). It
should be placed in a convenient location
where it can easily be drained, adjusted, and
filled with oil. The air hose must have at least a
1/2" (12mm) I.D. A quick-connect press-on
socket is installed on the stress spring end of
the hose for convenient hookup to the air tool.
Filter and lubricator bowls are made of
polycarbonate material. Do not install where
bowls may be exposed to materials incom-
patible with polycarbonate. Certain oils,
solvents, and chemicals or their fumes can
weaken these bowls and possibly cause them
to burst. Clean only with warm water. A cut-off
valve placed ahead of the filter will be useful
when cleaning the filter or replenishing the
lubricator.
Signode Pneumatic Accessories:
ITEM PART NO.
FRL W/ 10' HOSE 429141
FRL W/O HOSE 429130
QUICK-CONNECT SOCKET (LOW FLOW) 429134
QUICK CONNECT PLUG (LOW FLOW) 020704
QUICK-CONNECT SOCKET (HIGH FLOW) 015294
QUICK CONNECT PLUG (HIGH FLOW) 015293