Signode TENSION-WELD VFX-9/13, Руководство по эксплуатации, частям и безопасности

Страница: 26 / 30

26
MAINTENANCE
TOOL
1. Always be sure the tensioner foot is free and periodically lubricate the support pin.
2. Clean the teeth on the feedwheel and the gripper plug with the special brush provided, (Part
No. 023963).
3. Periodically clean the tool with an air hose.
4. Disassemble, clean and lubricate the welding mechanism.
GEAR HOUSING
Periodically check the gear housing portion of the tool:
1. Remove the end cap from the front of the gear housing by removing the set screw and
pulling the end cap off.
2. Check for adequate lubrication and wear of the Spiroid worm and gear.
3. This portion of the tool should be from 20% to 50% full of Non-Fluid Oil K-55.
4. Reinstall the end cap.