Signode LITTLE DAVID LX600, Руководство оператора

Страница: 44 / 91

made timer changes and has selected and pressed the 1 in
the box. When selected the state of the selected preset
changes to a black background indicated that this preset
timer (SAVE AREA) was selected. This timer change
sequence is also similar for the Swing Arm applicator and
Straight Tamp mode settings.
Additional note on Save Area information: When toggling
between the Tamp modes, the PLC will use the last Saved Areas
picked under each mode. For example, if save area 1 has been
previously selected for Single Tamp mode and Save Area 3 was
previously selected for Dual Tamp mode, these would be the
areas for timing that the labeler would be performing.
Press the desired mode to make setup changes. To change save
areas or time delays in the SINGLE TAMP mode, press the
SINGLE TAMP SETUP , the next screen will appear:
The PRODUCT DELAY is the time from which the product
sensor senses the leading edge of the product to when it tells the
labeler to apply the label. The
APPLY DELAY (Applicator
Delay) is the time the applicator arm is extended and engaging the
product.
NEXT button;
will go to the next
save areas.
Pressing NEXT
once will toggle to
the next Save
Area screen.
Timer box:
pressing the box
will activate the
individual timer
change screen.
ESC button; will
go to the Main
Screen.
Timer box:
pressing the box
will activate the
individual timer
change screen.
Save area box: pressing
the desired box will be
highlighted black and will
toggle between the save