Signode GRIPPACK, Оригинальное руководство по эксплуатации, частям и безопасности

Страница: 9 / 28

FIGURE 2 FIGURE 1
OPERATING INSTRUCTIONS
PLEASE NOTE: Do not operate tool without strap, as damage to the tool may occur.
Wear safety glasses and gloves. Stand to one side of the strap when sealing.
Make sure all bystanders are clear before proceeding.
SELECTING OPERATING MODE
The GripPack is easily changed from Manual Mode to Automatic
Mode. When in
MODE selection the tool will NOT operate.
1. Verify a battery is installed properly into tool.
2. Turn Tension Control Knob all the way counter clock wise to
enter
MODE selection (Figure 1).
a. 1 flash on the Operation Button = Automatic mode
b. 2 flashes on the Operation Button = Manual mode
Note: When entered into MODE selection the Operation
Button will flash the current mode.
3. Press the Operation Button to toggle between Automatic and
Manual modes (Figure 2).
4. When correct mode is selected turn Tension Control Knob
clockwise to the appropriate tension level (1 through 5).
Note: When exiting MODE selection the Operation Button will
once again flash the selected mode.
When the tension knob
is set between 1-5, the tool is ready to operate.
5. Tool is ready to operate.
Note: When inserting a new battery the operation button will typically flash indicating what
mode the tool is in. If the battery is changed very quickly within seconds the light may not
illuminate.
9