Signode DF-2D, Руководство по эксплуатации, частям и безопасности

Страница: 5 / 20

5
DF-2D LOADING AND THREADING INSTRUCTIONS
The DF-2D dispenser’s design allows for strap coils to be loaded independently of each other.
However the instructions are the same for loading either side. Use the threading diagram shown
on page 8 for reference. To load (or reload) a coil of plastic strap follow the steps below:
Strap coils can be heavy. To prevent back or other bodily injuries, your employer may also
contact the National Safety Council, Itaska, IL 60143 U.S.A. for additional information on
lifting techniques. Failure to follow the above could result in serious injury.
1. Remove the wing nut by turning it
counterclockwise. Remove the outer
reel disc assembly. If applicable, remove
the paper core and any plastic shrink
film residue left over from the previous
strap coil.
2. Position the new coil of strap on the
back disk so that the arrows printed on
the corrugated belly-band point in the
same direction as the arrow decal on the
inner reel disk.
Pay-off rotation must towards the rear of
the dispenser from the bottom of the
coil.
3. Reinstall the outer reel disc assembly.
Install and securely tighten the wing nut.
Continued . . .
Hand tighten the wing nut as mush as
possible.
Failure to snug the wing nut tightly
against the outer disk could result in the
disk and strap coil falling to the ground
or the wraps of the strap becoming
entangled.