Signode 120593, Руководство по эксплуатации

Страница: 6 / 56

6
05.20
Josef Kihlberg F560PN
5
INITIAL OPERATION
Fig. 3
5.1 INSTALLATION
The industrial stapler is delivered with the rear foot
dis-
assambled. Assemble as following:
1. Remove the industrial stapler and the rear foot
from the carton.
2. Assemble the rear foot according to Fig. 3.
Tighten the two screws, (Fig. 3/1).
3. Place the industrial stapler on level, firm and
cleanworking ground.
Lay the compressed air hose so that
there is no risk of tripping over it.
5.2 COMPRESSED AIR CONNECTION
Properly prepared compressed air is essen-
tial for troublefree operation of the industrial
stapler. This can only be ensured by a reliably functio-
ning maintenance unit, consisting of water separator,
pressure reducing valve with pressure gauge.
The internal diameter of the pipe should be at least
10 mm (
3
/
8
“).
The industrial stapler doesn´t need any lubrication.
Connect and adjust the air pressure to the lowest
possible, approx. 5,0 bars (72 psi), which clinch the
staples correctly.
Never exceed the maximum permitted air
pressure of 8 bar (110 psi). The maximum
supply pressure is 8 Bar (110 psi).
Low air pressure will give low mainte-
nance costs!
1