Signify Classified - Internal
page
12/11/2019
2
Installation instructions
SLF – Slip Fitter Mount
TULS/TULM/TULL
Note:
Tenon
must be 3.75” or longer.
ELECTRICAL CONNECTION
1.
Connect the black fixture lead to the input voltage
supply or Hot 1 (208V/240V/480V wiring).
2.
Connect the white fixture lead to the neutral supply
or Hot 2 (208V/240V/480V wiring).
3.
Connect the Green ground lead to the incoming
ground wire.
4.
If Dimming is an option, connect the purple dimming
positive lead to the supply dimming positive lead and
the grey dimming negative lead to the supply dimming
negative lead.
SLF- SLIP FITTER MOUNT
5.
Remove splice cover screws and splice cover to
access wire splice area.
6.
Route the supply wire through the tenon. Secure the
supply wire to keep from sliding back down the pole.
Route wire through slip fitter arm into splice area.
7.
Holding routed wires in splice area, carefully lower
luminaire onto tenon. Check to ensure that wires are
not pinched between inside of slip fitter and top of
tenon and that luminaire and wires rotate.
NOTE
:
Install luminaire as per traffic direction label
Screws
Latches
11 ft.-lbs
Note: 7 pin NEMA Twist Lock Receptacle option aiming
restricted to 0-90o per ANSI C136.10
