Signature Cuvee S63N, Руководство пользователя

Страница: 58 / 66

CLEANING AND CARE
Defrosting
Your wine cellar is designed with a "auto" defrosting
system. When the engine is stopped, the refrigerated
surfaces of the wine cellar defrost automatically. Defrost
water goes down into a drainage container, located near
the compressor at the back of the wine cellar. This water is
evaporated by the heat produced by the compressor.
Important : keep the drain hole and the gutter clean to
avoid clogging and water flow inside the wine cellar.
Cleaning
Important:
Before cleaning or restarting, first unplug the
power plug.
Never use abrasive products or scouring sponges for
cleaning inside or outside of your appliance.
·
Remove all accessories (shelves, water tank ...). Wash
them in lukewarm water with a mild, odorless
detergent (unscented for dishes, for example), rinse
with water and dry thoroughly.
·
Wash the inner walls in the same way; take special
care of the shelf supports.
Note : The door seal can come out of its location when
changing sides. If you notice openings between the joint
and the frame of the compartment when the door is
closed, pull carefully on the gasket to close these
openings. The correct positioning seal is important to
ensure the watertightness of your wine cellar.
Sometimes, it is necessary to heat the seal at a low
temperature in order to give him back his elasticity, then
he resumes its good position and tightness gradually.
-56-