Signature Kitchen Suite UPWD3034ST, Руководство по установке

Страница: 11 / 28

- 11 -
ENGLISH
INSTALL THE OVEN Part 4
1 CABINET INSTALLATION
The fifth step of the installation is to install the oven into the cabinet as follows:
1. Sliding the oven into the opening.
a. Loop (do not tie) a 36” (91 cm) string around the conduit before the oven is slid into place.This will keep the
conduit from falling behind the oven.
b. Lift oven into cabinet cutout using the oven opening as a grip. Carefully push against the oven front frame.
Do not push against outside edges.
c. While sliding the oven back, pull the string so that the conduit lies on the top of the oven in a natural loop.
d. When you are sure the conduit is out of the way, slide the oven 3/4 way back into the opening. Remove the
string by pulling on one end of the loop.
• DO NOT block the oven air exhaust
located at the bottom of the oven.
- Blocking the exhaust may cause cabinet
damage and product malfunction.
CAUTION
• Mounting screws must be used.
- Failure to do so can result in the oven falling
out of the cabinet causing serious injury.
WARNING
2. Securing the oven.
a. Using the mounting holes on the oven side trim
as a guide, drill pilot holes for screws provided
(For securing the double wall oven, use a
minimum of 4 screws, one on each side in both
the upper and lower ovens. For securing the
single wall oven, use a minimum of 2 screws, one
on each side.)
b. Secure the oven to the cabinet with screws
provided.
If the cabinet is particle board, you must use 3/4”
particle board screws. These may be purchased
at any hardware store.
3. Installing the metal bottom trim.
a. Place the metal bottom trim centered over the
pre-drilled mounting holes on the lower base.
b. Using 3 screws provided, secure the bottom trim
to the bottom edge of the cabinet.
4. Reinstalling the oven door.
- Ensure that the metal bottom trim is correctly installed.
- When you install the oven door, be carefull not to
bump the metal bottom trim.
Mounting
Hole
Locations
Mounting
Hole
Locations
Trim Screws
Side
Trim
Side Trim
Lower base
Metal Trim:
Correct
position
Metal Trim:
Wrong
position
Metal
bottom
trim
1 4/9”
(1.1 cm)
Step. 1
Firmly grasp both
sides of the door at
the top.
Step. 2
With the door at the
same angle as the
removal position,
seat the indentation
of the hinge arm into
the bottom edge of
the hinge slot. The
notch in the hinge arm must be fully seated into the
bottom of the slot.
Step. 3
Fully open the door. If the door will not fully open, the
indentation is not seated correctly in the bottom edge
of the slot.
Step. 4
Push the hinge locks up
against the front frame of
the oven cavity to the locked
position.
Step. 5
Close the oven door.
Hinge arm
Bottom
edge of
slot
Indentation
Hinge arm
Hinge lock