KESWICK FREESTANDING FAUCET INSTALLATION
7. Connect the braided water lines to the main water
supply at the floor. Ensure that you are connecting the
hot and cold lines accordingly. Apply thread sealant or
plumber’s tape to the threads before attaching. Hand
tighten firmly, then finish tightening using an adjustable
wrench. Be careful not to overtighten.
8. Briefly turn on the main water supply to ensure that
there are no leaks. Once you have determined that
there are no leaks, turn the water supply back off and
continue with the installation.
5. Drill pilot holes into the floor at the marked mounting
hole locations. The pilot holes should measure approxi
-
mately 1” deep and ¼” in diameter.
6. Remove the nuts, locking washers, and metal
washer from each of the mounting screws. Drop each
of the screws and anchors into the drilled pilot holes,
with the threads facing up through the floor.
3
Keswick Freestanding Faucet Installation Instructions
1”
Threading Facing Up
ON
OFF