EXIRA SHOWER SET INSTALLATION
5. To install the hand shower’s water supply elbow,
thread it onto the prepared 1/2” NPT pipe nipple. Apply
thread sealant or plumber’s tape to the threads before
tightening. Be sure to use the decorative escutcheon to
conceal the rough-in.
6. Determine a location to mount the hand shower’s
slide bar. Temporarily install the mounting brackets
onto the bar, and hold the bar against the wall at its
desired mounting location. Use a level to ensure that
the slide bar is straight, then mark the locations of the
mounting brackets by outlining them with a pencil.
Remove the bar, then attach the brackets to the wall
using the provided anchors and screws.
Important:
If drilling through tile, you must use a
masonry drill bit and drill carefully.
3. Attach the 3-way diverter handle to the top stem by
sliding it onto the spindle and tightening the set screw
underneath, using the provided hex wrench. Repeat
these steps to install the bottom single-function
handle.
4. To install the temperature control handle, loosen
the set screw and remove the handle from the handle
base. Attach the handle base to the center stem using
the provided screw. Tighten with a Phillip’s screwdriver,
then reattach the handle.
4
Exira Shower Set Installation Instructions
