SignaMax SC30010, Справочное руководство CLI

Страница: 473 / 671

Chapter 19
| Class of Service Commands
Priority Commands (Layer 2)
– 473 –
which each queue is polled for service, and subsequently affects the
response time for software applications assigned a specific priority value.
◆ Service time is shared at the egress ports by defining scheduling weights
for WRR, or for the queuing mode that uses a combination of strict and
weighted queuing. Service time is allocated to each queue by calculating a
precise number of bytes per second that will be serviced on each round.
◆ The specified queue mode applies to all interfaces.
Example
The following example sets the queue mode to strict priority service mode:
Console(config)#interface ethernet 1/1
Console(config-if)#queue mode strict
Console(config-ip)#
Related Commands
queue weight (473)
show queue mode (475)
queue weight
This command assigns weights to the eight class of service (CoS) priority
queues when using weighted queuing, or one of the queuing modes that use a
combination of strict and weighted queuing. Use the
no form to restore the
default weights.
Syntax
queue weight weight0...weight7
no queue weight
weight0...weight7 - The ratio of weights for queues 0 - 7
determines the weights used by the WRR scheduler. (Range: 1-255)
Default Setting
Weights 1, 2, 4, 6, 8, 10, 12, 14 are assigned to queues 0 - 7 respectively.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
◆
This command shares bandwidth at the egress port by defining scheduling
weights for Weighted Round-Robin, or for the queuing mode that uses a
combination of strict and weighted queuing (
page 472 ).
◆
Bandwidth is allocated to each queue by calculating a precise number of
bytes per second that will be serviced on each round.