SIGN RACER 1600 LED, Руководство по эксплуатации

Страница: 51 / 73

51
3.3 Overtime ink supplying
(three-­‐buzz signal)
Causes:
Check and see if the ink of the main tank is running out, refill it if so.
Click “reset” in the ink line options; check if the pump works properly by manual contact. Replace
the ink pump if so.
Check if there is any blockage of the pump, disconnect the bottom joint of the capsule filter and
click “reset” in the ink line option and see if the ink comes out of the tube, replace the pump if
not.
Check if there is blockage of the capsule filter, disconnect the upper joint of the capsule filter and
click “reset” in the ink line option and see if the ink comes out of the tube, replace the filter if not.
4. Printhead strike
4.1. How to avoid head strike with the media
The head height should be adjusted additionally after the automatic adjustment when printing on
some inflated or unsmooth or even some heat-­‐deformative media.
When printing on some heat-­‐formative materials, shut the non-­‐used suction sectors of the
platform. And cover the tiny holes of air leaking, so as to decline the possibility of deformation by
strengthen the corresponding suction.
The automatic head height adjustment must be run whenever changes material.
There is a certain distance between the head height detecting position and the datum point. If the
printed is too small to be detected when placed near the datum point, you may try and put the
media on the location for head height founder first and then move it to the printing position when
head height adjustment accomplishes.
Never try to lift the media positioning lever otherwise it may lead to head strike incident. Besides
the servomotor might come to an accidental stop by automatic protection and thus result in