Sigmann DELTA SD161BTex, Руководство по эксплуатации

Страница: 25 / 53

23 SD160BTex_BA_en_008.docx
10 Step-by-step guide on installation and operation
10.1 Preparation handheld scanner for system assembly 1 and 2
Do not replace accu in hazardous areas.
Incorrect handling may result in the termination of the operating
permit.
The accu compartment is located at the bottom of the Bluetooth
handheld scanner. Loosen the screw to remove the lid.
Open accu compartment
After the screw has been loosened, the removal of the
lid requires a certain amount of force.
An SD.Z10.0018.00 accu is required to operate the Bluetooth
handheld scanner.
Only use this accu for the Bluetooth Scanner!
Before placing the accu inside the scanner, remove its protective cap.
Insert the accu into the accu compartment of the scanner. The end of
the removal strap must protrude from the opening.
If the accu has been correctly inserted and connected
to the contacts, this will be indicated by an acoustic
and a visible signal.
Close the compartment.
Check that the screw has been tightened properly.