Sigma TAURO 35, Инструкция по эксплуатации и обслуживанию

Страница: 10 / 48

Instructions, use and maintenance manual Pag. 10/48 TAURO 35-35PLUS-40-40PLUS
5. Customer set-ups
The environmental conditions of the location where the machine is installed must have the following features:
•
Humidity-free.
•
Water and heat sources at an appropriate distance.
•
Appropriate ventilation and lighting that is compliant with the hygiene and safety standards required by the laws
in force. The floor must be level and compact in order to favour proper cleaning.
•
Do not place in the immediate vicinity of the machine, obstacles of any nature that may affect the normal
operation and ventilation of the machine in question (leave about 250 mm free around the machine, especially
on the side, where the master switch is located, leave 1000mm).
•
Upon machine arrival, ensure it is intact. Any damages incurred during transport or delivery must be
immediately reported.
•
Ensure that the power supply matches that of the machine: check the plate on the machine and on the wiring
diagram (chap. 18). Connection to the line MUST be done via a CE standard blocked socket, fitted with three
valves adequate to the amount of current absorbed during machine operation.
The electrical mains must have an automatic circuit breaker with adequate features to those of the
machine, where the opening distance between contacts is at least 3 mm. In particular, an earthing
system compliant with current regulations is essential.
5.1. Instructions for ordering spare parts
SIGMA S.r.l., reserves to make all changes it deems necessary to its machine models.
It is, therefore, always necessary to specify:
•
Type of machine
•
Year of manufacture
•
Position
•
Description
•
Serial no.
•
Required number of parts.
Address your request to:
Sigma S.r.l.
via Artigianato 85,
25030 Torbole Casaglia (BS) Italy
Tel 030 265 04 88 - Fax 030 265 01 43
www.sigmasrl.info - Email: info@sigmasrl.info
Check that the system power supply voltage and frequency are compatible with the
values indicated in the technical features and on the plate affixed to the machine.