9
INPUT RANGE SELECTION
With the ‘SCALE’ selection highlighted by the cursor, press ‘ENTER’ to access the input scale menu.
Use the Up/Down arrow buttons to select the desired analog input range.
NOTE: INPUT TYPE MUST
BE CO-ORDINATED WITH INPUT SELECTOR SWITCH LOCATED ON THE BOTTOM OF
THE
CIRCUIT BOARD
(See Appendix ‘A’).
Press ‘ENTER’ to save and move to decimal point selection screen.
Decimal Point Selector Screen
The cursor will be positioned over the decimal count window, use the Up/Down arrow buttons to raise or
lower the unit number to the left of the decimal point. (The example shown in this window will change
with your selection.)
Use the buttons to move the cursor to the number behind the decimal point and the
Up/Down buttons to change this selection. Once again the example will change to confirm your selection.
Use the buttons to highlight the ‘NEXT’ selection and press ‘ENTER’ to access the Input
Scale Screen.
Input scaling to Engineering units