4/15
has been thoroughly tested for safety prior to shipment. However, mishandling
during use could result in injury or death, as well as damage to the device. Be
certain that you understand the instructions and precautions in the manual before
use .We disclaim any responsibility for accidents or injuries not resulting directly
from device defects.
To avoid short circuits and potentially life-threatening hazards,
follow these precautions:
Never attach the clamp to a circuit that operates at more than the maximum rated
voltage to earth.
For safety’s sake,avoid clamping around bare conductors,while clamping or
measuring.
While clamping and measuring, do not touch the clamp in front of the barrier or
the conductor being measured.
Be careful to avoid damaging the insulation surface while taking measurements.
Make sure that the waveform measuring equipment connected to this device's
output terminal (BNC) is equipped with a protective earthing with double-
insulation construction.
Do not allow the device to get wet, and do not take measurements with wet hands.
This may cause an electric shock.
If the waveform measuring instrument being connected to the output terminal
(BNC) on this device is equipped with any other measurement terminals, take the
following precautions to ensure that the other instrument does not form a bridge
between the probe and any hazardous live part of a part.
1.
Isolate the terminal to which the probe is connected from other terminals on
the measuring instrument using basic insulation conforming to the
measurement category, working voltage, and pollution degree requirements of
the circuit being tested.
2.
If basic insulation requirements cannot be met between the terminal to
which this device is connected and other terminals of the measuring instrument,
make sure that the voltage input to the measurement terminal does not exceed
the Separated Extra- Low Voltage Earthed.
3.
Read and observe all warnings and precautions relating to electrical
WARNING
