EAN-1500-OEM-Startup-Guide
© SightLine Applications, Inc.
3
5
Hardware Bench Setup
IMPORTANT
: To prevent damage to the hardware boards, use a conductive wrist strap attached to
a good earth ground. Before picking up an ESD sensitive electronic component, discharge built up
static by touching a grounded bare metal surface or approved anti-static mat.
This section describes the connection for the 1500-OEM and the 1500-AB interface board to the
supporting components. The 1500-AB board is used as the serial and network interface board.
Cable connections:
IMPORTANT:
See
in the next section before applying power.
•
Attach the heat sink to the top of 1500-OEM board. The heatsink has peel-and-stick backing.
•
SLA-
CAB-2RCA: Connects to VIN0 on the 1500-AB board and to the analog camera.
•
SLA-
CAB-2RCA (optional analog monitor): Connects to VOUT on the 1500-AB board and to analog
monitor.
•
SLA-CAB-ETH0: Connects to the Ethernet port on the 1500-AB board and to the network switch or
host PC. A green blinking light on the 1500-OEM board verifies network connection.
•
SLA-PWR-B05V (110-250VAC input / 5VDC output): Connects to J2 on the SLA-1500-AB board.
The camera and monitor are not provided by SightLine Applications.
Figure 3: Typical Bench Hardware Setup
Ethernet Port
Network Switch or PC
Direct
VOUT
VIN1
VIN0
SLA-PWR-B05V
1500-OEM board +
1500-AB Board
Serial (optional)
Analog
Monitor
Analog Camera
SLA-CAB-2RCA
SLA-CAB-ETH0
SLA-CAB-2RCA
Heatsink
Camera PWR
The board and
heatsink unit can
become very warm
during operation.
Use care when
handling. Do not
remove the heatsink
during bench
testing.
