.
The first thing that you need to do is to identify and mark the part numbers on the laser cut parts using the drawings on the
following pages as a guide.
It is possible that several of the laser cut parts may not be completely cut through. If this is the case you can free the part from
the sheet quickly using an X-acto knife.
NOTE: The slight discoloration on the edges of the laser cut parts may be removed by lightly sanding the edges with 400 grit
sandpaper.
Beginners Note
These instructions were written assuming that the builder has previous building experience. If this is your frrst model then we
recommend that you purchase a copy of the following book:
Rubber Powered Model Airplanes By: Don Ross
This excellent book covers basic building and flying procedures and provides valuable information about all aspects of building
and flying rubber powered model airplanes.
