.
63. While holding the motor you should adjust the thrust line so that the prop shaft is pointing straight ahead or with a slight
amount of right thrust. When the mounts are properly positioned, drill through the mount and parts EM with a 1/32" drill bit.
64.
Remove the motor and mounts and install 2-56 blind nuts on the bottom of parts EM. Reinstall the motor and mounts using
2-56 screws.
65.
WITHOUT THE PROPELLER ATTACHED, hook up the radio and power system and test the motor for proper operation.
Do Not install the propeller until after you have again tested the power system after the model is covered and is completely
ready for flight.
66.
Now jump ahead in the instructions to the covering section.
Glow Powered Version
67.
Mark and drill 1/16" holes on F-16G for the motor mount. Attach the motor mount to the firewall with 4-40 screws and nuts.
Now install the motor on the mount. Trim the top front corner of the fuselage side to allow for needle valve access and
clearance.
68.
Mark and drill 3/16" holes in the firewall for the throttle pushrod, fuel and vent lines.
69.
Glue the F-19 fuel tank supports into position.
70.
Assemble the fuel tank and install into the model.
71.
Bend and install the throttle pushrod. Attach the pushrod to the servo with a servo connector.
Covering
72.
Remove the motor, motor mount, control surfaces , landing gear and other items. Sand the entire model smooth with 320
grit sandpaper. Remove the hatch from the model and cover it separately.
73.
Cover the model with your choice of iron on covering materials.
74.
Cut the windows to shape using the patterns on the plan and apply to the model. An ultra fine Sharpie Marker can be used
to draw panel lines and other details. Paint the wing hold down dowels and the F-19 landing gear retainers.
Final Assembly
75.
Install the elevators and then the rudder to the model and glue the hinges in place. Install the ailerons on the model the
same way if you are using them.
76.
Install the servos in the model. If you are using ailerons, cut two 1/2" dia. holes in the lower wing sheet aft of the main spars
and just outboard if the nylon tape at the center of the wing. Use the thread to feed the servo wires through the wing.
(Control horns and aileron pushrods are not provided in the kit)
77.
Install the pushrods and control horns and connect the pushrods to the servos.
78.
Glue the wing hold down dowels into position. Paint or cover the ends.
79.
Install the landing gear. Cover parts LG. Attach to the wire strut with a strip of covering material. Apply a small amount of
silicone rubber to attach them to the fuselage side.
Electric Powered Version
If you are building the Glow Powered Version, Skip ahead to step #84.
80.
Install the power system back in the model.
81.
Securely glue two Velcro straps to the bottom of part F-9 to hold the battery into your model.
Содержание Cloud Ranger HHR508
Страница 2: ... ...