20
TIG Welding
1.
Insert the earth cable plug into the positive socket on the front of the machine and tighten it.
2.
Plug the welding torch into the negative socket on the front panel, and tighten it.
3.
Connect the gas line of TIG Gun to outlet gas connector on the front of the machine.
4.
Connect the control cable of torch switch to 12 pin socket on the front of the machine.
5.
Connect the water inlet and outlet pipe of TIG Gun to inlet and outlet water connector on the front
of the water box.
6.
Connect the control cable of water box with the aero socket on the rear panel of welding machine.
7.
Connect the gas regulator to the Gas Cylinder and connect the gas line to the Gas Regulator. Check
for Leaks!
8.
Connect the gas line to the machine inlet gas connector via the quick push lock connector located
on the rear panel. Check for Leaks!
NOTE:
Air cooling mode without cooling device, and the water pipe is not needed for the air cooling
mode.
9.
Connect the power cable of welding machine with the output switch in electric box on site.
Turn on the power switch.
10.
Carefully open the valve of the gas cylinder, set the required gas flow rate.
11.
With a multi meter measure the input voltage is within the fluctuation range.
12.
The power ground is well grounded.
INSTALLATION & OPERATION
2
§3.4 Installation & Operation for TIG welding
§3.4.1 Set up installation for TIG Welding
(1) Insert the earth cable plug into the positive socket on the front of the machine and
tighten it.
(2) Plug the welding torch into the negative socket on the front panel, and tighten it.
(3) Connect the gas line of TIG Gun to outlet gas connector on the front of the machine.
(4) Connect the control cable of torch switch to 12 pin socket on the front of the machine.
(5) Connect the water inlet and outlet pipe of TIG Gun to inlet and outlet water connector
on the front of the water box.
(6) Connect the control cable of water box with the aero socket on the rear panel of
welding machine.
