SifWeld Evolution TS320ACDC, Руководство по эксплуатации

Страница: 11 / 28

11
2. Control Panels
INSTALLATION & OPERATION
1
Outlet (5) and inlet (6) for MIG
The two nozzles on the same side of Control connector (4) are used for MIG operation
and can be connected to the nozzles on the wire feeder. Blue corresponds to the outlet:
cold water is delivered from the tank; red corresponds to the backwater inlet: hot water is
flowed into the tank for cooling.
Note
: Blue outlet and red backwater inlet must not be wrong!
§3.2 Layout for Control panel
§3.2.1 Control panel
1. Welding mode key : Press it to select MMA/ HF TIG/ Lift TIG welding mode.
2. Output waveform key.*
3. Trigger mode selecting key : Press it to select 2T or 4T trigger mode.
4. Welding function key : Press it to select the opening or closing of Pulse mode and
Spot welding mode.
5. JOB key : Press it for 3s to open JOB program and press it for 1s to save parameters
into JOB number.
6. Function A key.*
7. Parameter A key : Press it to select Hot start or Balance. If the key is not pressed
within 3s, the selection will be automatically removed.
8. Screen : It will show all welding parameters, such as welding voltage, welding current
1. Welding mode key
Press it to select MMA/ HF TIG/ Lift TIG welding mode.
2. Output waveform key.
3. Trigger mode selecting key
Press it to select 2T or 4T trigger mode.
4. Welding function key
Press it to select the opening or closing of Pulse mode and Spot welding mode.
5. JOB key
Press it for 3s to open JOB program and press it for 1s to save parameters into JOB number.
6. Function A key
7. Parameter A key
Press it to select Hot start or Balance. If the key is not pressed within 3s, the selection will be
automatically removed.
8. Screen
It will show all welding parameters, such as welding voltage, welding current and other parameters set.
9. Parameter B key
Press it to select Arc Force or AC Frequency. If the key is not pressed within 3s, the selection will be
automatically removed.
10. Cooling mode selecting key
Press it to select Air cooling or Water cooling.
11. Function B key
12. Parameters select/adjust knob