4 to 11
The installation must conform with local codes, or in the absence of local codes, to the national fuel gas code,
ANSI Z223.1 (or latest addenda). The Appliance and its individual shut off valve must be disconnected from the
gas supply piping system during any pressure testing of that system in excess of ½ PSI (3.45Kpa).
The appliance must be isolated from the gas supply piping system by closing its individual manual shut off valve
during any pressure testing of the gas supply piping system at test pressures equal to or less than ½ PSI (3.45Kpa).
The gas supply line must be at least the same size as the gas inlet of the appliance.
FLEXIBLE COUPLINGS, CONNECTORS AND CASTERS
For an appliance equipped with casters the installation shall be made with a connector that complies with the
Standard for Connectors for Movable Gas Appliances, ANSI Z21.69 or Connectors for Moveable Gas Appliances,
CAN/CGA-6.16, and a quick.
–
disconnect device that complies with the standard for Quick Disconnect Devices for Use with Gas Fuel, ANSI
Z21.41, or Quick Disconnect Devices for Use with Gas Fuel, CANI-6.9. Adequate means must be provided to limit
the movement of the appliance without depending on the connector and the quick-disconnect device or its
associated piping to limit the appliance movement.
Restraining devices may be attached to the back frame/panel of the unit.
All Sierra appliances are adjusted and tested before leaving the factory, effectively matching them to sea level
conditions. Adjustments and calibrations to assure proper operation may be necessary on installation to meet
local conditions; low gas characteristics, to correct possible problems caused by rough handling or vibration
during shipment, and are to be performed only by qualified service personnel. These adjustments are the
responsibility of the customer and/or dealer and are not covered by our warranty. Before lighting any pilots,
make sure that burner valves and thermostats are turned “off”.
MAINTENANCE INSTRUCTIONS
CAUTION
: Never use ammonia in an oven that is warmer than room temperature and always have direct
ventilation!
If the appliance is on casters and is connected to the supply piping by means of a connector for movable
appliances, there is a restraining device at the rear of the unit. If disconnection of the restraint is necessary,
reconnect the restraint after the appliance has been returned to its originally installed posit
ion.
CLEANING
