SIERRA VIDEO SYSTEMS
2
Regulatory Warnings & Safety Information
The information in the following section provides important warnings and safety guidelines for
both the operator and service personnel. Specific warnings and cautions may be found
throughout this manual. Please read and follow the important safety precautions noting especially
those instructions relating to risk of fire, electrical shock and injury to persons.
Any instructions in this manual that require opening the equipment cover or enclosure are
intended for use by qualified service personnel only. To reduce the risk of electrical shock, do not
perform any servicing other than what is contained in the operating instructions unless you are
qualified.
Warnings
Heed all warnings on the unit and in the operating instructions.
Disconnect AC power before installing or removing device or servicing unit.
Do not use this product in or near water.
This product is grounded through the grounding conductor of the power cord. To avoid
electrical shock, plug the power cord into a properly wired receptacle before connecting
inputs or outputs.
Route power cords and other cables so that they are not likely to be damaged, or create a
hazard.
Dangerous voltages exist at several points in this product. To avoid personal injury, do
not touch unsafe connections and components when the power is on.
To avoid fire hazard, use only the specified type, correct voltage, and current rating of
fuse. Always refer fuse replacement to qualified service personnel.
Have qualified personnel perform safety checks after any completed service.
To reduce risk of electrical shock, be certain to plug each power supply cord into a
separate branch circuit employing a separate service ground.
If equipped with redundant power, this unit has two power cords. To reduce the risk of
electrical shock, disconnect both power cords before servicing.
Operate only with covers and enclosure panels in place – Do Not operate this product
when covers or enclosure panels are removed.
This is an FCC class A product. In a domestic environment, this product may cause radio
interference, in which case the user may be required to take necessary measures.
Cautions
Use the proper AC voltage to supply power to the switcher. When installing equipment,
do not attach the power cord to building surfaces.
To prevent damage to equipment when replacing fuses, locate and correct trouble that
caused the fuse to blow before applying power.
Use only the recommended interconnect cables to connect the switcher to other frames.
