Sierra C100L-L-DD-LE-5-OV1-SV1-PV1C-V1-S1, Инструкция по эксплуатации

Страница: 32 / 55

Sierra Instruction Manual MaxTrak 180
32
Choose the correct gas for your current application and click. The new gas selection will appear in the box.
Within a few seconds, the new gas selection will also appear in the yellow Flow box and the values of the mass
flow, setpoint and the full scale will be adjusted for this new gas. This is normal. In some cases, where the
thermal properties of one gas are very similar to another, these values may not change very much.
4.7.3 Change Units
This box will show the current engineering units. Should you wish to change the engineering units, use the pull-
down menu.
Make your selection, noting that each engineering unit is available with 3 different time constants: seconds, minutes
and hours. Choose the combination of units and time constants you desire, then click. The box will display your
new selection. Within a few seconds, the units will change in the Flow, Setpoint, and Full Scale boxes and the
numerical values will be adjusted into the new units.
4.7.4 Change Analog Out
This box will show the two analog output signals currently selected for your instrument. To re-configure the analog
output signals, use the pull-down and make your selection. The SmartTrak will adjust the analog output voltage
signal per your instruction.