Rev 2 Jun.15
Proprietary and Confidential - Contents subject to change
19
Consider using a U.FL extraction tool to put less strain on the connector
during removal.)
·
If the board has SMA connectors, screw the antenna onto the desired
connector.
Insert/Remove IoT Modules
The mangOH Development Board includes three IoT module slots.
If the board uses module mounting rails and you want to use a 2-slot or 3-slot
IoT module, remove the rail(s) between the slots you will be using.
Caution:
Handle IoT modules carefully to make sure components are not accidentally
damaged, and hold modules by their edges to avoid possible ESD damage.
To install an IoT module:
1.
Check the IoT module to make sure you know which side is the top. (Modules
must not be inserted upside-down.)
2.
Insert the module parallel to the mangOH Development Board. (Do not try to
insert at an angle as this may damage the module or connector.)
·
IoT slot with mounting rails—Slide the IOT module into the rails until it
meets the connector, then press firmly to seat the module into the
connector.
Figure 3-14: Insert IoT Module via Rails
·
IoT slot with screw mounts—Position the module so the pins lightly engage
the connector, and the other end of the module is supported by the mounts.
Press firmly to seat the module into the connector, and secure the module
in place using screws provided.