A24205-A334-B832 (Edition 1)
P/N 315-035600-2
7
Figure10
Location Of The ZAM-180 On The CAP-MP
The ZAM-180 can occupy any position on the mounting plate, but is normally
installed on the right side of the Mounting Plate (Refer to Figure 10). When
the ZAM-180 is mounted correctly on the Mounting Plate it will be flush on
the top, bottom, and right with the Mounting Plate and the mounting screw
holes of the PSC-12 will align with the threaded posts.
Figure 11
Mounting the ZAM-180 On The CAP-MP
1.
Install four 10-32 (M5) screws in the threaded posts at the
mounting position. Screw each of the 10-32 (M5) screws into the
threaded posts 5-6 turns.
2.
Place the ZAM-180 over the four screws on the Mounting Plate
and slide it down or towards you to rest on the four screws.
(Refer to Figure 11.) When the ZAM-180 is in the correct position
it will be flush with the top, bottom and right side of the
Mounting Plate.
3.
Tighten the four screws.
